Centering calculator
Measured your card with a ruler or calipers? Type the four borders here and see the ratios, and how high each grading company lets that centering grade.
The ratios show here once all four are filled in.
The ratios show here once all four are filled in.
Any unit works, millimetres being the usual one, as long as all four on a side use the same unit.
How to use it
- Measure each border on the front: from the card's edge to where the border ends, on the left, right, top and bottom. Measure in the middle of each side.
- Type the four widths. The ratios appear as you go.
- Do the same for the back if you can. Graders judge it separately, and a back past the limit can cost a 10 on its own.
- Press Check the limits to see each company's limit for a 10, and how high the centering lets the card grade.
Not sure how to measure? How to measure card centering walks through a ruler, calipers and a centering overlay. Our printable centering ruler lets you read each border straight off the card.
Which company suits the card?
The result shows all five companies at once, which makes it a quick way to see where a card's centering does it justice. Some things you'll often notice:
- PSA, CGC and TAG share a front limit of about 55/45 for a Gem Mint 10, so a front either clears all three or misses all three, give or take TAG's reading.
- The back is where they part ways: PSA and CGC allow 75/25, TAG about 65/35 on a trading card, and Beckett 55/45 for a centering 10.
- Beckett shows a centering subgrade, and its final grade will not exceed half a point above the lowest subgrade.
- ACE shows a centering score; a 10 is anything better than 60/40.
The full tables are in centering by grading company.
About TAG's row
TAG measures cards by machine, and its reports put a card a little further from 50/50 than a ruler does, most of all left to right on the front. The calculator converts your measurements to the way TAG reads a card before comparing them with TAG's limit, the same as Preslab does for a photo. That's why TAG's row can say "Not a 10" when PSA's says "Clear".
A few things worth knowing
- Units don't matter. A ratio is the same in millimetres, inches or the marks on a ruler, as long as all four borders on a side use the same one.
- Precision matters near a limit. On a card whose borders add up to 5 mm, a tenth of a millimetre moves the ratio by about two points. If your result is close to 55/45, measure again, or check the card from a photo.
- Tilted prints: if a border is wider at one end than the other, measure both ends and use the worse pair.
- Nothing is kept. Only the numbers you type are sent, to work out the limits, and nothing is stored.
Centering is one of four things a grade weighs, with corners, edges and surface. Preslab is not affiliated with PSA, TAG, BGS, CGC or ACE.
Photograph the front and back. Preslab measures the centering and shows how high PSA, TAG, BGS, CGC and ACE let it grade. Free, and centering only.